Brother HL-2140 Quick Setup Manual page 6

Safety Precautions
International ENERGY STAR
Statement
The purpose of the International ENERGY STAR
Program is to promote the development and
popularization of energy-efficient office equipment.
As an ENERGY STAR
Ltd. has determined that this product meets the
ENERGY STAR
IEC 60825-1 specification (220 to 240 volt model
only)
This printer is a Class 1 laser product as defined in
IEC 60825-1+A2: 2001 specifications. The label
shown below is attached in countries where it is
needed.
This printer has a Class 3B laser diode which
produces invisible laser radiation in the laser unit. You
should not open the laser unit under any
circumstances.
Caution
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Internal laser radiation
Maximum radiation power:
Wave length:
Laser class:
IMPORTANT - For Your Safety
To ensure safe operation, the supplied three-pin plug
must be inserted only into a standard three-pin power
outlet that is properly grounded through the normal
household wiring.
Extension cords used with this printer must be three-
pin plug type and correctly wired to provide proper
grounding. Incorrectly wired extension cords may
cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily
does not imply that the power is grounded and that
the installation is completely safe. For your safety, if
in any doubt about the effective grounding of the
power, call a qualified electrician.
This product should be connected to an AC power
source within the range indicated on the rating label.
DO NOT connect it to a DC power source. If you are
not sure, contact a qualified electrician.
6
®
Compliance
®
Partner, Brother Industries,
®
guidelines for energy efficiency.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT
10 mW
780 - 800 nm
Class 3B
Disconnect device
You must install this printer near a power outlet that is
easily accessible. In case of an emergency, you must
®
disconnect the power cord from the power outlet to
shut off the power completely.
Caution for LAN connection (HL-2150N only)
Connect this product to a LAN connection that is not
subjected to over voltages.
Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with
the following code:
Green and Yellow: Earth
Blue:
Brown:
If in any doubt, call a qualified electrician.
Neutral
Live