Cub Cadet Z-Force S Commercial 48 Operator's Manual page 21

3. Attach the hose coupler to the water port on your decks
surface. See Figure 6-2.
Nozzle Adapter
Adapter Lock Collar
Figure 6-2
4. Turn the water on.
5. While sitting in the operator's position on the tractor, start
the engine and place the throttle lever in the FAST
position.
6. Move the tractor's PTO (Blade Engage) into the ON position.
7. Remain in the operator's position with the cutting deck
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8. Move the tractor's PTO (Blade Engage) into the OFF
position.
9. Turn the ignition key to the STOP position to turn the
tractor's engine off.
10. Turn the water off and detach the hose coupler from the
water port on your deck's surface.
11. Repeat step 4-10 on the opposite side of the cutting deck.
After cleaning your deck with the Smart Jet™ system, return to
the operator's position and engage the PTO. Keep the cutting
deck running for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly dry.
Lubrication
Front Wheels
Deck Wash Nozzle
Each of the front wheel spindles and rims is equipped with a grease
fitting. See Figure 6-3. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
WARNING!
Before lubricating, repairing, or
inspecting, always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
Grease
Fittings
Figure 6-3
S 6 — M
ection aintenance
& a 21
djuStMentS