Weslo Pursuit 6.0 Dx Bike User Manual page 7

8. The Console (16) requires three AA batteries (not
included); alkaline batteries are recommended. Insert
three batteries into the Console as shown in the inset
drawing. Make sure that the batteries are oriented
as shown by the markings inside the Console.
While another person holds the Console (16), attach
the ground wire to the Handlebar (15) with an M4 x
12mm Screw (25). Next, insert the excess ground wire
into the Console, and insert the console wire down
through the indicated hole in the Handlebar.
Attach the Console (16) to the Handlebar (15) with
four M4 x 16mm Screws (49). Be careful to avoid
pinching the ground wire and the console wire.
9. While another person holds the Handlebar (15) near
the Upright (13), connect the console wire to the
Extension Wire (36). Next, attach the Handlebar to the
Upright with two M8 x 15mm Screws (34) and two M8
Split Washers (42). Be careful to avoid pinching the
console wire and the Extension Wire.
10. While another person holds the Upright (13) in the
position shown, connect the Extension Wire (36) to
the Reed Switch Wire (43). Next, connect the
Resistance Cable (19) to the Lower Cable (45) in the
following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (45), and insert the tip of the
Resistance Cable (19) into the wire clip inside the
metal bracket as shown.
• See drawing B. Firmly pull up the Resistance Cable
(19) and slide it into the top of the metal bracket as
shown.
• See drawing C. Using pliers, squeeze the prongs on
the upper end of the metal bracket together.
Push the excess wire and cable down into the Frame
(1), and slide the Upright (13) onto the Frame. Be care-
ful to avoid pinching the wires and cables. Attach
the Upright with two M8 x 15mm Screws (34) and two
M8 Split Washers (42).
8
Batteries
16
49
9
Console
34
42
10
43
1
A
Metal
Bracket
19
45
7
Console
Wire
25
Hole
Ground
15
Wire
36
15
13
13
34
42
42
36
19
45
B C
Metal
19
Bracket
45
16
Wire