Charge Your Battery - JVC GC-XA1 Detailed User Manual

Charge your battery

You must use JVC authenticated adapter (AC-V17LU) and the USB cable. Connect USB cable, press
< / > to select [Adapter], and then press [SET] button.
A blinking light will indicate active charging.
In adapter charging mode, the full charging time for a depleted battery is about 3.5 hours and the light
will turn off automatically after the charging is completed.
In PC USB charging mode, a longer charging time is required.(about 5.5 hours)
Note
• Never charge the battery by a method other than as instructed. Doing so may cause a fire or
explosion possibly resulting in serious injury.
• Use JVC authenticated adapter (AC-V17LU) only with the indicated power supply voltage.
• Use with any other power supply voltage might cause electric shock.
• Be sure that the power outlet you plug the adapter into is easily accessible. When you need to
disconnect power from the camera, be sure to unplug the power cord from the electrical outlet.
• It is not feasible to take a video while adapter is applied, though Endless REC/Time Lapse
would still work.
Inserting and Removing a SD Card (Optional)
1. Remove the battery cover and the battery.
2. Insert the memory card into the slot until it locks properly.
3. To remove an installed SD card, press the card inwards to release it.
4. When the card pops out, gently remove it from its slot.
5. Recommended memory capacity: 2GB or above.
10
EN