JVC VN-H657U Instructions Manual page 26

4 Mount the fall prevention wire to the
camera (for connecting the ceiling
mount section to the camera).
Mount the fall prevention wire, which is
0
attached to the camera, to the fall prevention
wire fixing bracket of the ceiling mount
section.
Caution
The camera may fall if the fall prevention
0
wire is not connected. Be sure to connect
the fall prevention wire.
For safety purposes, do not leave the fall
0
prevention wire dangling by the camera.
5 Mount the camera and check the
camera lock knob.
Align the "D mark (blue)/(red)" inside the
0
camera with the "D mark (blue)/(red)" on the
ceiling mount section.
Mount the camera securely by inserting it
0
into the ceiling mount section until you hear
a click sound.
If the camera is mounted on securely, the
0
camera fixing lock knobs (x2) will stick out a
little.
Fall prevention wire
fixing bracket
D mark
(blue)
.
Note :
Before mounting the camera, check that the
0
camera fixing lock knobs are not locked (i.e.,
lock knobs are on top). The camera cannot be
mounted if the lock knobs are locked.
When pulling out the cables from the side,
0
remove the cable cover of the camera.
(A P24 [Pulling out the cables from the side] )
Mounting the Camera (VN-H657U)
26
4
D mark (red)
Fall-prevention
Wire on Camera
Check the knob.
During
mounting
5
After
mounting
6 Lock the camera fixing lock knobs (x2)
When the camera is mounted on the ceiling
0
mount section, lower the camera fixing lock
knobs (x2) in the direction of the arrow and
secure the camera such that it does not fall
off.
.
Caution
The camera may fall if the camera fixing lock
0
knobs (x2) are not locked. Be sure to check
that the lock knobs are firmly locked.
Improper mounting may cause the camera
0
to fall off. After mounting, check that the
camera is mounted securely.
Installation of the camera is complete. Next, set
the IP address of the camera.
(A P32 [IP Address Setting Procedure] )
Removing the Camera
1 Release the lock by sliding the camera
fixing lock knobs toward the ceiling.
2 Press the two camera fixing lock
knobs from both the left and right
sides to remove the camera unit.
3 Remove the fall prevention wire by
performing the mounting procedures
in the reverse sequence.
Camera fixing
lock knob (x2)