Installing The Server; Checking Components; Required Tools - NEC N8100- 1241F User Manual

INSTALLING THE SERVER

With N8100-1241F/1242F/1243F/1244F/1245F/1246F/1313F/1314F/1327F/
1328F/1329F/1330F/1331F/1332F
This subsection provides the instructions for the rack-mount server unit into a standard EIA 19-inch
rack cabinet. Also this subsection describes the removal procedures for the rack-mount server unit
from the 19-inch rack cabinet.
Observe the following instructions to use the server safely. Failure to follow these
instructions may result in death or serious personal injury. See pages 1-3 to 1-8
for details.
Observe the following instructions to use the server safely. Failure to follow these
instructions may cause a fire, personal injury, or property damage. See pages 1-
3 to 1-8 for details.

Checking Components

Confirm that the following tools or components are provided to install the server on the rack.

Required Tools

Prepare a Phillips screwdriver and a flat tip screwdriver to install the server on the rack.
Do not use any rack which does not conform to the relevant standard.
Disconnect the power cord(s) before installing or removing the server.
Do not leave more than one device being pulled out from the rack.
Do not lift the server only by a single person.
Always install the server in the specified place.
Do not install the server on the rack leaving the cover removed.
Do not pinch your finger with mechanical components.
x 8
6
M5 screw
WARNING
CAUTION
x10
M5 core nut
Setting Up Your Server 3-5