Samsung Laptop User Manual page 81

Using the TPM Security Device
5
When the system reboots, press the corresponding key(s) by
following the onscreen instructions.
6
When the computer restarts automatically and the Samsung
logo screen appears, press the F2 key repeatedly.
7
Select the Security > TPM Configuration > Change TPM
Status item and set the item to Enable and Activate.
Aptio Setup Utility - Copy (C) 2012 American Megatrends, Inc.
8
Press the F10 key to save the changes.
9
When the system reboots, press the corresponding key(s) by
following the onscreen instructions.
10
Press the F10 key to save the changes. The computer
automatically restarts. Initialization of the TPM chip has been
completed. Now, install the TPM program and register the
TPM program.
TPM Device Enabled
Clear
TPM State
Enabled & Activate
Security Chip State
Clear
Enabled & Activate
Deactivate & Disable
(Optional)
Installing the TPM program
You can install the TPM program as follows. Install the program
according to the procedures below.
This program is only provided for models with Recovery and
the TPM function.
1
Turn the computer on and immediately press the F4 key
several times.
2
After a moment, the Recovery program runs.
Click System Software.
3
When a pop-up window appears to ask you to reboot the
system, click Yes.
The system starts to reboot. After a moment, the SW Update
program automatically runs.
4
Connect to the network.
5
Select TPM Host SW and click Install.
6
After the program is completely installed, click Close.
7
Close the SW Update window and reboot your computer
again.
Chapter 3.
80
Using the computer