Installation - Tripp Lite SmartOnline SU1000RTXL2U Owner's Manual

200608121 93-2609 SU Owner's Manual.qxd

Installation

Mounting
Rackmount
1) Loosen the wingnuts on each of the two UPS
Side Supports; adjust the length of the supports to
match the depth of your rack; tighten wingnuts.
2) Mount both UPS Side Supports in your rack on
the inside surfaces of the rack rails.
Note: Both support ledges should face inward. The side supports'
front and back holes are threaded and do not require nuts to
secure rack bolts.
3) Attach mounting 'ears' to the front end of the
UPS's sides using the screws provided.
4) Lift UPS and slide it onto the UPS Side
Supports within your rack. Mount the UPS by
screwing rack bolts through the UPS mounting
'ears', through the rack rails and through the UPS
Side Supports.
Note: The side supports' front holes are threaded and do not
require nuts to secure rack bolts.
Vertical Tower Mount
1) Cover the rackmount screw holes on the UPS's
sides with supplied snap-in hole-cover caps.
2) Place the UPS upright in a flat, stable location
with its control panel on the high corner facing
forward. Position stabilizer feet 4 in. from each
end of the UPS.
10/3/2006 3:32 PM
SU2200RTXL2U shown
SU2200RTXL2U shown
3
Page 3