Using The Audio/Video Input Jacks; Connecting A Vcr Or Dvd Player - Sanyo CLT2054 Owner's Manual

USING THE AUDIO/VIDEO INPUT JACKS

CONNECTING A VCR OR DVD PLAYER

Switch off TV and external equipment before con-
necting cables. (Cables are not supplied.)
1
Connect VCR, DVD Player, or other equipment's
Audio Video Out to the TV Audio Video Input.
For Mono VCR (Single Audio Jack) connect
VCR Audio Out to TV Audio (L) Input.
1 1 2 2
Optional ( / )
Connect DVD Player or other equipment's
S-Video Out to the TV S-Video In Jack.
BACK VIEW OF VCR
1
IMPORTANT NOTE FOR
MONITOR USE:
If you did not connect an
antenna, you must run All
Channel Search
before you can select the
AV inputs.
I
Press the INPUT key after connecting cables to access the
A / V Inputs. There is NO need to tune to a blank channel.
I
Make sure all cable connectors are fully seated on jacks.
I
Always match A/V cables according to the colors; red for
right audio, white for left audio and yellow for video.
TV AV INPUT JACKS
twice
Need help?
Using the S-Video jack overrides the Video (AV1)
jack.
Connect DVD Player or other equipment's Audio
Out to the TV Audio In Jacks.
2
Press POWER to turn on the TV. Turn on exter-
nal equipment also.
3
Press the INPUT key to select VIDEO1 or
VIDEO2.
DVD PLAYER
2 2
1 1
REMOTE CONTROL
3
I
A solid Blue screen with the word VIDEO1 or VIDEO2,
displayed means that the Video mode is selected, but
no signal is being detected at the Video jacks. Check
connections, turn on external equipment.
www.sanyoctv.com
Visit our Web site at
What you will need
for connections:
1
A/V Cable – 1
O C
PTIONAL ONNECTION
1
S-Video Cable – 1
2
Audio Cable – 1
2
1-800-877-5032
or Call
9