The Live View Page - Axis 210 User Manual

5. From the Focus adjustment page, set the DC-Iris to Enabled and click Save.
Note:
The DC-Iris should always be disabled while focusing the camera. This opens the iris to its maximum, which
gives the smallest depth of field and thus the best conditions for correct focusing. When the focus is set
with this method it will then be maintained in any light conditions.

The Live View Page

Depending on whether or not the Live View page has been customized, the buttons
described below may or may not be visible.
To resize the video image, click the View Size buttons: half-size (x
full-size (x1), x2 or x4. Note that this does not change the video
image's resolution, but simply how it is displayed. Changing the View
size is not available in Sequence Mode.
From the Video Format list, select the desired video stream format.
Note that Multicast has to be enabled if MPEG-4 is selected. This is
configured under Setup > System Options > Network > RTP
(multicast).
The Output buttons control the output directly from the Live View page.
These buttons are configured under Setup > Live View Config > Layout.
Pulse - click this button to activate the port for a defined period of time, e.g. to
switch on a light for 20 seconds.
Active/Inactive - click these buttons to manually start and stop a connected
device, e.g. switch a light on/off.
These buttons start and stop the Sequence Mode. This mode is created in
Setup > Live View Config > Sequence mode, and automatically displays the
view from 2 or more video sources at set intervals.
The Action buttons can trigger an event directly from the Live View page.
These are configured under Setup > Live View Config > Layout.
The Snapshot button saves a snapshot of the video image currently being
displayed. Right-click on the video image to save it in JPEG format on your
computer. This button is primarily intended for use when the AMC viewer
toolbar is not available.
From the Source list, select the desired external video source. Note
that Sequence Mode must be stopped before selecting a source from
this list.
AXIS 210/211/211A - Accessing the Camera
11
),
1
/2