EMU29492
Replacing fuse
If the fuse has blown on an electric start
model, open the fuse box and use a fuse
puller to replace the fuse with a spare one of
the proper amperage.
EWM00630
WARNING
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
ECM01382
CAUTION:
If a main fuse has blown, be sure to also
G
check the other main fuse.
If the outboard motor is operated after a
G
main fuse has blown charging capabili-
ty will be insufficient, and the engine
will not start.
Trouble Recovery
4
3
2
5
1
1. Electrical cover
2. Fuse holder
3. Fuse (20A × 3, 30A × 1, 80A × 2 )
4. Spare fuse (20A, 30A, 80A)
5. Fuse puller
1
1. Fuse puller
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29520
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt/ the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit/the power tilt, the en-
gine can be tilted manually.
1.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
3
4
ZMU04009
ZMU03562
72