Invacare Rea Spirea4 NG User Manual page 29

A
B
Tool: 4 mm Allen key
10 mm socket spanner
ONE ARM DRIVE
The one arm drive enables you to move the wheel-
chair with one hand. Two hand rims are installed on
the same wheel. The drive wheel can be fitted on the
right or left side.
1a. Remove the drive wheel
Remove the drive wheel by pulling the button (A)
and pulling the wheel off the wheelchair.
1b. Fitting the drive wheel
When you put the wheel back, pull the button (A),
upwards and secure the drive wheel to the hub.
It is very important that you check that the lock
catch has actually locked the wheel when you
let go of the button. Test this by trying to pull
the wheel off. This should NOT be possible.
The hand rims can either be placed flush to each other
(internal position) or with the inner, smaller, hand rim
sticking out (external position).
2. Changing the hand rim's position.
Loosen the three screws (B), take off the hand rim
and turn it over. Put the hand rim back and screw
the screws tight again.
C
Be careful when you remove the telescopic
drive shaft. Point it away from your body
when you release the powerful steel spring
found inside.
NB! The drive shaft (C) is an important part of the
wheelchair. Without this part the user would be
unable to move the wheelchair.
Be careful not to get your fingers trapped bet-
ween the drive wheel's spokes and the outer
D
hand rim's three brackets (D).
29