Installation - Wells UT Series Operation Manual

INSTALLATION

NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the dispenser for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
Risk of
personal injury
Installation of heated
dispensers must be performed
by a qualified technician with
full knowledge of all applicable
electrical codes. Failure can
result in personal injury and
property damage.
CAUTION:
Electric Shock
Hazard
The ground prong (largest
brass prong) of the power
cord is part of a system
designed to protect you from
electric shock in the event of
internal damage to the
dispenser.
NEVER CUT OFF A PRONG
and NEVER TWIST A
PRONG TO FIT AN
EXISTING RECEPTACLE.
Contact a licensed electrician
to install an electrical
receptacle appropriate to the
voltage and amperage
requirements of the dispenser.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
UNPACKING & INSPECTION
Carefully remove the dispenser from the carton. Remove all
protective plastic film, packing materials and accessories from
the dispenser before connecting electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the dispenser before starting any
installation.
Read and understand all labels and diagrams attached to the
dispenser.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a
convenient place for later use.
PREPARATION
Carefully read the Installation Instruction Sheet packed with the
dispenser for cutout dimensions and restrictions.
Refer to the Installation Instruction Sheet for required
clearances. Maintain required clearances between heated
dispensers and adjacent combustible surfaces.
Avoid storing flammable or combustible materials near heated
dispensers.
ELECTRICAL
Heated dispensers must be installed by a licensed electrician in
accordance with all applicable codes and ordinances.
Refer to the nameplate. Verify the electrical service power.
Voltage and phase must match the nameplate specifications.
Plugging the appliance into the wrong voltage can severely
damage the equipment or cause noticeably decreased
performance.
4