Installation - Wells BT-218T Operation Manual

INSTALLATION

NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
CAUTION:
Electric Shock
Hazard
The ground prong of the
power cord is part of a system
designed to protect you from
electric shock in the event of
internal damage to the appli-
ance.
NEVER CUT OFF THE
GROUND PRONG (large
round prong).
NEVER TWIST A PRONG TO
FIT AN EXISTING
RECEPTACLE. Contact a
licensed electrician to install
an electrical receptacle
appropriate to the voltage and
amperage requirements of the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
Appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Setup the appliance only on a firm level surface. Non-combustible
material (e.g. metal, tile or terrazzo) is recommended.
Avoid storing flammable or combustible materials near the appliance.
Rubber support pads are provided. The pads must be properly
installed, and all four pads must be in firm contact with the counter to
prevent tipping or "walking".
ELECTRICAL
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Plugging the
appliance into the wrong voltage can severely damage the equipment
or cause noticeably decreased performance.
Your appliance is equipped with a grounded electric power cord. This
cord must be plugged into a properly grounded electrical receptacle.
4