Advertisement
1. AC Power/Voltage Selector:
This amplifier can operate at AC currents of 100V, 110V, 120V, 230V.
the correct voltage with the arrow, and plug back in. After selecting the correct voltage, connect the AC power cord the wall socket.
2.
MIDI IN/THRU:
Connect the included footswitch to the MIDI IN jack. The MIDI IN is the main input for the MIDI connection, and can be used with
various multi-button MIDI foot controllers. The MIDI THRU passes the signal on to other MIDI capable units, such as external effects
processors. Once the footswitch is connected to the MIDI IN, button 1 is used to select the CLEAN channel, button 2 selects the
standard O.D. channel, and button 3 selects the FRY mode or gain boost function. Button 4 is used for turning the loop on/off,
See effects loop below.
3. Assign able Effects loop:
Warning: ALL LOOP ASSIGN BUTTONS MUST BE IN THE OUT POSITION WHEN NOT USING THE EFFECTS LOOP . IF A BUTTON IS
This specialized series loop has several features which should be understood before using. First, each channel can be manually
selected for use with the external effects that are connected to the Send/Return jacks. This allows you to assign the channels used
with the loop. To activate any or all channels to work with the loop, simply press in the small buttons located in the effects sections.
Leave the button in the OUT position for channels not used with the loop. Once you have selected the channels you want with the
loop, you can select and change the channels using the included foot controller or front panel channel select button. When using but-
ton 4 (Loop on) on the footswitch, please note each effects loop button must be in the out (off) position, to manually turn the effects
loop on/off using the footswitch.
The footswitch "Loop On" button will not activate or bypass the effects if the rear effects loop buttons are pressed in.
4.
Slave Out w/Level control:
A basic preamp signal output, this output is used to connect directly to other power amps if more power is needed. The level control
adjusts the amount of volume level output.
5.
Speaker outputs:
Using a high quality speaker cable, connect either jack to the input on your speaker cabinet. Connect a single cable for mono
operation, or connect both speaker outs to the left/right inputs on speaker cabinet for stereo operation.
REAR PANEL FEATURES
Simply remove the fuse with a small screwdriver, and line up
Advertisement
