General Care & Cleaning - Kenmore 790.3103 Use & Care Manual

General Care & Cleaning (cont'd)
Removing and Replacing Warmer (Warm & Ready™) Drawer
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
To Remove Warmer Drawer:
1. Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Figure 1).
4. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1. Pull the plastic slider to the front of the glide slots on each side of
the drawer cavity (See Figure 2).
2. Align the glide on each side of the drawer with the drawer cavity glide
slot.
3. Push the drawer into the drawer cavity until glide levers "click"
(approximately 2"). If you do not hear the glide levers "click" or the
drawer does not feel seated remove the drawer and repeat steps 1
thru 3.
Note: The Warmer Drawer will NOT operate while in the "Self-Clean" and
"Oven Lockout" modes
Changing the Halogen Oven Light (some models)
The oven lights will automatically turn ON when the oven door is opened. The
oven lights may also be manually operated by pressing the
The oven light bulb is covered with a glass shield. The glass shield can be
removed to be cleaned manually or to change oven light. THIS GLASS SHIELD
MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. To remove the glass shield, lift up on side with gloved finger and use force
to pull shield out.
4. Replace halogen light appliance bulb taking care not to touch the bulb with
your bare fingers. Touching bulb with your skin can leave a film on the bulb
that causes it to burn out quickly.
5. Replace glass shield in opposite order and manner of removal.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield,
change bulb and be sure to replace glass shield.
Electrical Shock Hazard can occur and result
Changing the Oven Light (some models)
Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do not turn the oven light on during the self-cleaning cycle. High temperature will reduce
lamp life.
The interior oven light will turn on automatically when the oven door is opened.
The oven lights may also be manually operated by pressing the
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
Left Glide
Pull down lever
with finger
pad.
Lift backside
of glass shield
and remove it.
45
Lever
Pull up lever
with finger
Lever
Right Glide
Figure 1
Figure 2
Halogen
Light Bulb
pad.