Setting Up Your P-520 Camera; General Precautions; Installing The Camera - First Alert P-520 User Manual

G P
ENERAL RECAUTIONS
Use only the power supply provided with the system.

Unplug the power supply when the system is not in use for extended periods.

Do not place any of the equipment near a radiator, vent, or other place where it

might be exposed to heat, moisture, dust, vibrations, or strong magnetic fields. If
any liquid comes into contact with the camera, turn off the power immediately and
have a qualified technician inspect the equipment before using it again.
Do not attempt to repair the camera. Contact a qualified technician or the dealer for

service. Any change or modification may damage the equipment and invalidate the
warranty.
When installing the camera, follow manufacturer's advice when using power tools,

steps, ladders, etc. and wear suitable protective equipment (e.g., safety goggles)
when drilling holes. Before drilling holes through a ceiling, check for hidden
electricity cables and water pipes.
I C
NSTALLING THE
1
Select the position for the camera and secure the camera
stand.
Screws and anchors are supplied. Use an appropriate screw
type for the mounting surface.
2
Screw the camera onto the stand. Tighten the lock nut to
secure the camera on the stand.
3
Adjust camera to the proper view angle. Make sure the
lens is upright relative to your subject. Tighten the thumb
screw.
4
Connect the camera to power using the supplied power
cable and adapter.
AMERA
Setting Up Your
P-520 Camera
4
lock nut
thumb screw
camera stand