Table of Contents
Advertisement
Information: Display the information about WPS IE on the selected network. List
information includes Authentication Type, Encryption Type, Config Methods, Device
Password ID, Selected Registrar, State, Version, AP Setup Locked, UUID-E and RF
Bands. Its detail follows WPS Information on AP.
4. PIN Code: 8-digit numbers for external Registrar or internal Registrar using PIN
method. Each NIC Wireless has only one PIN Code.
5. Table of Credentials: Display all of credentials got from the Registrar. List
information includes SSID, MAC Address, Authentication and Encryption Type.
Credentials are created as soon as each WPS success and deleted as soon as PIN or
PBC start.
6. Control items on credentials
① . Detail: Information about Security and Key in the credential.
② . Connect: Command to connect to the selected network inside credentials.
The active selected credential is as like as the active selected Profile.
③ . Rotate: Command to rotate to connect to the next network inside credentials.
④ . Disconnect: Stop WPS action and disconnect this active link. And then select
the last profile at the Profile Page if exist. If there is an empty Profile page, the
driver will select any non-security AP.
⑤ . Delete: Delete an existing credential. And then select the next credential if
exist. If there is an empty credential, the driver will select any non-security
AP.
7. PIN: Start to add to AP using PIN configuration method.
PBC: Start to add to AP using PBC configuration method.
*When you click PIN or PBC, please don't do any rescan within two-minute
connection. If you want to abort this setup within the interval, restart PIN/PBC or
press Disconnect to stop WPS action.
38
User Manual V1.0
Advertisement
Table of Contents
