Compressed Air System - Grizzly H5626/7 Instruction Manual

Compressed Air System

The Model H5626/H5627 is designed to be
operated at 60-100 psi. Do not exceed
the maximum operating pressure for
your model.
Before you use your new stapler, install the
1 ⁄ " quick connect fitting that comes with the
4
stapler. Install a female
hose. Regulate the air pressure on your air
compressor to barely over the minimum psi
for your model.
Many pneumatic tools benefit from an in-
line filter/lubricator/regulator unit. Using
this unit protects your tool from damaging
water build-up, allows you to adjust and
maintain constant air pressure to your tool,
and saves you the inconvenience of having
to manually lubricate your tool every time
you use it. Check the current Grizzly cata-
log for availability of this unit. If you plan on
installing a filter/lubricator/regulator unit in
your compressed air system, always follow
the connection instructions that come with
the unit.
Exceeding the maximum permissible
operating pressure may cause the sta-
pler to explode, blowing metal frag-
ments in all directions. To protect
yourself from serious personal injury,
DO NOT allow your air compressor to
exceed the recommended pressure
when connected to this stapler!
H5626/H5627 Upholstery Stapler
1
⁄ " fitting on the air
4
Oiling Stapler
Special oil has been included with you new
Grizzly stapler to help maintain its useful
life. Place one drop of oil in the stapler air
inlet (as shown in Figure 1) before every
use. Wipe off any excess oil near the sta-
pler exhaust to avoid dust build-up. When
the oil that was included with the stapler
has been completely used, replace with
Grizzly Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
stapler will not be necessary. Just make
sure there is always oil in the lubricator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit in
your air line.
Figure 1. Lubricating stapler via air inlet.
-5
-