Compressed Air System - Grizzly H7678 Instruction Manual

18 gauge deep stapler kit
Hide thumbs Also See for H7678:
Table of Contents

Advertisement

Compressed Air
System
The Model H7678 is designed to be oper-
ated at 60-100 PSI using clean, dry, regu-
lated, compressed air. DO NOT exceed
the 120 PSI maximum operating pres-
sure for your model.
Before using your new stapler, regulate
the air pressure on your air compressor to
the minimum PSI for your model.
An in-line filter/lubricator/regulator unit,
depicted in Figure 2, can be installed and
should be located as close to the stapler
as possible.
This filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Quick
Connector
Your
Tool
Quick
Coupler
Figure 2. Typical filter/lubricator/regulator installation order.
-6
-
Quick
Connector
Quick
Air Hose
Coupler
Exceeding the maximum permissible
operating pressure may cause the
stapler to explode, blowing metal frag-
ments in all directions. To protect
yourself from serious personal injury,
DO NOT allow your air compressor to
exceed the recommended pressure
when connected to this stapler!
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Lubricator
Regulator
Filter
H7678 18 Gauge Deep Stapler Kit
Air
Compressor

Advertisement

Table of Contents
loading

Table of Contents