Roger Beep Confirmation Tone - Cobra microTALK CXT280 Owner's Manual

Mode Functions
Operation
Privacy Code Scan
Your microTALK radio can automatically scan the Privacy Codes (either
CTCSS 01 through 38 or DCS 01 through 83) within one channel. Only
one set of privacy codes (CTCSS or DCS) can be scanned at a time.
To scan privacy codes:
Select Channel
1. While in Standby mode, press the Channel Up or
Channel Down button to choose the channel on
which you wish to scan privacy codes.
2. Press the Mode/Power button until either the
Mode/Power
CTCSS or the DCS icon appears on the display
and the Scan icon and the privacy code numbers
flash on the display.
3. Press the Channel Up or Channel Down button
Scan Privacy Codes
to begin scanning privacy codes within the
channel you selected.
is on. Your radio will continue to scan privacy codes and stop as an
incoming transmission is detected. Your radio will remain on that
channel/privacy code for 10 seconds.
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that channel/
privacy code. Your radio will remain on that channel/privacy code
and return to Standby mode.
b. Press the Channel Up or Channel Down button to
resume scanning privacy codes. If you do not press any button
within 10 seconds, your radio will automatically resume scanning
privacy codes.
c. Press the Lock button to return to Standby.
12
Introduction
Five Call Tone Settings
•
You can choose between five different Call Tone Settings to transmit
a call alert.
Mode/Power
Call Tone Setting
Channel Button

Roger Beep Confirmation Tone

Your listener will hear an audible tone when you release the
Talk button. This alerts the other party that you are finished
talking and it is OK for them to speak.
Mode/Power
Roger Beep Off
Channel Button
Operation
Customer Assistance Warranty
To change a call tone setting:
1. Press the Mode/Power button until the
letter "C" and the current call tone number
(01 through 05) is displayed. The current
call tone will sound for one second.
2. Press the Channel Up or Channel Down button
to hear the other call tone settings.
3. Choose one of the following:
a. Press the Mode/Power button to
enter the new setting and proceed
to other functions.
b. Press the Lock button to enter the new setting
and return to Standby mode.
To turn roger beep on or off:
1. Press the Mode/Power button until the
Roger Beep icon flashes. The current
on or off setting is displayed.
2. Press the Channel Up or Channel Down button
to select roger beep on or off.
3. Choose one of the following:
a. Press the Mode/Power button to enter the
new setting and return to Standby mode.
b. Press the Lock button to enter the new setting
and return to Standby mode.
Nothing Comes Close to a Cobra
•
•
13
®