Table of Contents
Advertisement
01GB00TMEM860.book Page 15 Monday, October 16, 2006 1:50 PM
Information
In Case of Difficulty
If you encounter a problem, please turn the power off, then on again.
If the unit is still not functioning normally, please review the items
in the following checklist. This guide will help you isolate the
problem if the unit is at fault. Otherwise, make sure the rest of your
system is properly connected, or then consult your authorized
Alpine dealer.
Basic
No function or display.
• Vehicle's ignition is off.
- If connected according to the instructions, the unit will not
operate with the vehicle's ignition off.
• Improper power lead connections.
- Check power lead connections.
• Blown fuse.
- Check the fuse on the battery lead of the unit; replace with the
proper value if necessary.
No sound or unnatural sound.
• Connections are not properly or securely made.
- Check the connections and firmly connect.
Screen not displayed.
• Brightness control is set at the minimum position.
- Adjust the Brightness control.
• Temperature in the vehicle is too low.
- Increase the vehicle's interior temperature to operation
temperature range.
• Connections to the DVD, navigation system are not securely
made.
- Check the connections and firmly connect.
Unclear or noisy display.
• Fluorescent plate is worn out.
- Replace the fluorescent plate.
Navigation system inoperative.
• Connections to the navigation system are incorrect.
- Check the connections with the navigation system and connect
the cables correctly and firmly.
Unclear picture display.
• Fluorescent tube is exhausted.
- Replace the fluorescent tube*.
* The fluorescent tube replacement is not free of charge even within the
warranty period, for the tube is an article of consumption.
Unit does not operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
No picture is produced.
• Monitor's mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
• Monitor's parking brake lead is not connected.
- Connect the monitor's parking brake lead and set the parking
brake.
(For details, refer to the monitor's instructions.)
01GB06TMEM860.fm
• Monitor's parking brake is not set.
- Connect the monitor's parking brake lead and set the parking
brake.
(For details, refer to the monitor's instructions.)
Picture is unclear or noisy.
• Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
• Monitor's fluorescent tube is worn.
- Replace the monitor's fluorescent tube.
Spots or dotted lines/stripes appear.
• Caused by neon signs, high-voltage power lines, CB transmitter,
other vehicle's ignition plugs, etc.
- Change the location of your vehicle.
Specifications
MONITOR SECTION
Screen Size
7.0-type
LCD Type
Transparent type TN LCD
Operation System
TFT active matrix
Number of Picture Elements 1,152,000 pcs.
Effective Number of Picture Elements
99.99% or more
Illumination System
Cold cathode fluorescent tube
GENERAL
Power Requirement
14.4 V DC
(11–16 V allowable)
Weight
(Monitor Section) 680 g
(1 lbs. 8 oz)
CHASSIS SIZE (Monitor section)
Width
178 mm (7")
Height
100 mm (3-15/16")
Depth
145 mm (5-45/64")
• Due to continuous product improvement, specifications and design
are subject to change without notice.
• The LCD panel is manufactured using an extremely high precision
manufacturing technology. Its effective pixel ratio is over 99.99%.
This means that there is a possibility that 0.01% of the pixels could
be either always ON or OFF.
ALPINE TME-M740BT 00-00000Z00-A (EN)
15
-EN
Advertisement
Table of Contents
