Yaesu FTdx5000 Series Operating Manual page 32

P.BACK ( A
Once engaged by the operator, the FT
audio on the VFO-A by plugging in the supplied FH-2 Remote Control Keypad into the rear panel's REMOTE jack. This
capability is especially useful for confirming a callsign that may have been difficult to copy due to noise or QRM, etc.
Recording
ˆ Press and hold in the FH-2's [ P/B ] key for two sec-
onds to initiate recording. The "
pear in the display to confirm that recording is in
progress.
ˆ Press the FH-2's [ P/B ] key momentarily to halt re-
cording; the " " icon will go out.
ON
Start
15 Seconds
FT 5000 O
DX
PERATING
P
UDIO LAYBACK
5000 begins the automatic recording of the last 15 seconds of incoming receiver
DX
" icon will ap-
LOCK
OFF
Stop
M
ANUAL
C
ONVENIENCE
) ( VFO-A ) R
M
FROM AIN
Playback
ˆ Press the FH-2's [ P/B ] key briefly, after recording has
been halted, to begin playback of the recorded audio;
the " " icon will appear in the display to confirm
that playback is in progress. The last 15 seconds of
audio will be heard in the speaker or headphones. If
you do not intervene, the entire 15 seconds will be
played back endlessly.
ˆ To halt playback at any time, just press the [ P/B ] key
briefly again. The next time you press the [ P/B ] key, it
will pick up the playback where you left off.
A
DVICE
You may adjust the playback level of the recording by the
main [ AF GAIN ] knob.
F
EATURES
ECEIVER
Page 45