Sub Display - Yaesu FTdx5000 Series Operating Manual

F P
RONT ANEL
[ CLAR ( VFO-B )] Knob
The function of this knob is different by the setting of
three switches located above this knob. See next page
for details.

SUB DISPLAY-

II
This LCD display shows the character of the VFO-A
receiver's DSP function selected by the five buttons
located below of this display, and the ( VFO-
A )[ SELECT ] knob located below this window works
as an adjustment knob that displayed to this window.
Furthermore, when the Menu Mode is activated, this
LCD display indicates the Menu item.
( VFO-A )[ VRF/—-T ] Switch
This button turns the VFO-A receiver's contour filter
"on" and "off", and allows you to adjust the center fre-
quency of the VRF filter by the ( VFO-A )[ SELECT ]
knob. While activated, the red imbedded LED in this
button will light up, and the "
the FLT column of the Block Diagram Display on the
display.
A :
DVICE
When the optional RF —Tuning Kit is connected, press-
ing this button will engage the —-Tuning filter. The
—Tuning Kit provides much better RF selectivity than
any other RF filter in the Amateur industry, yielding
outstanding protection from high RF levels not far re-
moved from the current operating frequency.
Page 26
C
ONTROLS
" icon will appear in
& S
WITCHES
( VFO-A )[ SHIFT ] Switch
Pressing this button allows you to move the IF DSP
bandwidth of VFO-A "higher" or "lower" by the ( VFO-
A )[ SELECT ] knob. When the IF passband is shifted,
the red LED imbedded in this button will light up. To
the contrary, when the IF passband is just centered, the
red LED imbedded in this button turns off.
( VFO-A ) [ CONT/APF ] Switch
In the SSB, AM, and FM modes, this button turns the
VFO-A receiver's contour filter "on" and "off", and
allows you to adjust the center frequency of the con-
tour filter by the ( VFO-A )[ SELECT ] knob. When the
contour filter is activated, the red imbedded LED in
this button will light up.
In the CW mode, this button turns the VFO-A receiver's
APF (Audio Peak Filter) "on" and "off", and allows
you to adjust the bandwidth of the APF filter by the
( VFO-A )[ SELECT ] knob. When the APF filter is ac-
tivated, the red imbedded LED in this button will light
up.
( VFO-A ) [ NOTCH ] Switch
This button turns the VFO-A receiver's IF notch filter
"on" and "off", and allows you to adjust the center fre-
quency of the notch filter by the ( VFO-A )[ SELECT ]
knob. When the notch filter is activated, the red im-
bedded LED in this button will light up.
FT 5000 O
DX
M
PERATING ANUAL