Radio Shack 12-1631 Owner's Manual

Dual Alarm AM/FM Clock Radio
CONNECTING AC POWER
Plug the clock radio's power cord into
standard AC outlet. The display lights.
Caution: The clock radio's AC power cord is
equipped with a polarized plug to prevent
electric shock. One blade on the cord's plug
is wider than the other and the plug only fits
an outlet one way. If you can not easily insert
the plug, turn it over and try again. Do not
force it.
WARNING:
To reduce the risk of fire or
shock hazard, do not expose this product to rain
or moisture.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION:
TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
This symbol is intended to alert
you to the presence of uninsu-
lated dangerous voltage within
the product's enclosure that might
be of sufficient magnitude to con-
stitute a risk of electric shock. Do
not open the product's case.
This symbol is intended to inform
you that important operating and
!
maintenance
included in the literature accom-
panying this product.
OWNER'S MANUAL — Please read before using this equipment.
INSTALLING A BACK-UP
BATTERY
a
If AC power fails, the clock radio's Battery
Sentinel back-up power system continues to
operate the clock for up to 8 hours with the
display turned off to conserve power. This
lets the alarm sound for at least 10 minutes
at the preset time, even if AC power fails.
Your clock radio requires a 9-volt battery (not
supplied) for back-up power. For the best
performance and longest life, we recom-
mend a RadioShack alkaline battery.
Caution: Use only a fresh battery of the re-
quired size and recommended type.
!
When the BATTERY SENTINEL icon
pears, replace the battery.
Warning: Dispose of old batteries promptly
and properly. Do not bury or burn them.
Caution: Always remove an old or weak bat-
tery. Battery can leak chemicals that can de-
stroy electronic parts.
instructions are
©
2001 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
1. Press the battery compartment cover's
tab, then lift off the cover.
2. Snap the battery onto the connector and
place it in the compartment.
3. Replace the cover.
used by RadioShack Corporation.
¢
#ap-