1200 System Board Assembly - Lenovo ThinkPad SL410 Hardware Maintenance Manual

Table 29. Removal steps of top shielding assembly (continued)
For ThinkPad L412:
Step Screw (quantity)
1
M2 × 3 mm, wafer-head, nylon-coated (3)
2
M2 × 5 mm, wafer-head, nylon-coated (3)

1200 System board assembly

Important notices for handling the system board:
When handling the system board, bear the following in mind.
• The system board has an accelerometer, which can be broken by applying several thousands of G-forces.
Note: Dropping a system board from a height of as little as 6 inches so that it falls flat on a hard bench
can subject the accelerometer to as much as 6,000 G's of shock.
• Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or
composite.
• If a system board is dropped, you must test it, using PC-Doctor for DOS, to make sure that the HDD
Active Protection still functions (see below).
Note: If the test shows that HDD Active Protection is not functioning, be sure to document the drop in
any reject report, and replace the system board.
• Avoid rough handling of any kind.
• At every point in the process, be sure not to drop or stack the system board.
• If you put a system board down, be sure to put it only on a padded surface such as an ESD mat or
conductive corrugated material.
94
ThinkPad SL410, L410, L412, SL510, L510, and L512 Hardware Maintenance Manual
Torque
Color
Black 0.181 Nm
(1.85 kgfcm)
Black 0.181 Nm
(1.85 kgfcm)