Table of Contents
Advertisement
Step
Screw (quantity)
1
M2 × 3 mm, flat-head, nylon-coated (2)
2
M2 × 5 mm, flat-head, nylon-coated (3)
1200 System board assembly
• To identify the system board originally installed in your computer, go to PEW at the following web site:
http://www.lenovo.com/support/site.wss/document.do?lndocid=LOOK-WARNTY
Select Warranty Lookup. Input the machine type and the serial number. Use the system board listed on
PEW.
Important notices for handling the system board:
When handling the system board, bear the following in mind.
• The system board has an accelerometer, which can be broken if several thousands of G-forces are applied.
Note: Dropping a system board from a height of as little as 6 inches so that it falls flat on a hard bench
can subject the accelerometer to as much as 6,000 G's of shock.
• Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or
composite.
• If a system board is dropped, you must test it, using PC-Doctor for DOS if the system supports PC-Doctor
for DOS, to make sure that the HDD Active Protection System™ still functions.
Note: If the test shows that the HDD Active Protection System is not functioning, be sure to document the
drop in a reject report, and replace the system board.
• Avoid rough handling of any kind.
• At every point in the process, be sure not to drop or stack the system board.
• If you put a system board down, be sure to put it only on a padded surface such as an ESD mat or a
corrugated conductive surface.
If the system supports PC-Doctor for DOS, after replacing the system board, run PC-Doctor for DOS to
make sure that the HDD Active Protection System still functions. The procedure is as follows:
1. Place the computer on a horizontal surface.
2. Run Diagnostics ➙ ThinkPad Devices ➙ HDD Active Protection Test.
Attention: Do not apply physical shock to the computer while the test is running.
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 59
• "1020 ExpressCard blank bezel and Media Card blank bezel" on page 61
•
"1030 Optical drive or travel cover" on page 62
•
"1040 Thermal cover" on page 63
•
"1050 Hard disk drive (HDD) assembly" on page 64
•
"1060 DIMM" on page 65
•
"1070 Fan assembly" on page 66
•
"1080 CPU" on page 69
•
"1090 SIM slot cover" on page 70
• "1100 Wireless WAN slot cover and PCI Express Mini Card for wireless WAN" on page 72
•
"1110 Palm rest assembly with cables" on page 74
Color
Torque
Black
0.181 Nm
(1.85 kgfcm)
Black
0.181 Nm
(1.85 kgfcm)
.
Chapter 8
Removing and replacing a FRU
91
Advertisement
Table of Contents
