Table of Contents
Advertisement
4.5 Installation
Satellite Name
Frequency
LNB Setting
Motorized DiSEqC 1.2
DiSEqC Command Mode
Movement
If you have DiSEqC 1.2 motorized system, then you can use
the DiSEqC 1.2 functions.
Select a satellite name that will be used to identify a motor
position.
Select the transponder to catch the strong signal. Select the TP
from TP list box to get the strong signal.
Please refer to Section
Select Enable or Disable. If you are using DiSEqC 1.2 antenna,
set to Enable.
Change the current mode between User and Installer modes.
User:
This mode is used to fine-tune the position of the motor
for better reception.
Installer:
This mode is used to search for the position of a
satellite manually.
In case of User mode, the movement is adjustable by fine-
tuning. In case of Installer mode, the movement is adjustable
by East, West going command.
4.5.1
on page 27.
33
Advertisement
Table of Contents
