Feed Roller Tension; Chip Deflector - Grizzly G9740 Instruction Manual

Extreme-duty planers
Hide thumbs Also See for G9740:
Table of Contents

Advertisement

Feed Roller Tension

The feed roller spring tension is factory set and
should require no initial adjustments, unless
needed for a special type of stock. If a situation
develops where the workpiece does not feed
straight, adjustments to one roller may be neces-
sary. Usually if the board is moving to one side,
that side needs more pressure.
Open the left cabinet door and locate the spring
above the feed block (directly above the adjust-
ment bolt from the previous instructions). Turn
the nut counter-clockwise to increase the spring
tension.
In general, rough stock or deeper cuts require
more feed rate pressure (more spring tension).
Shallow cuts need less feed rate pressure. Too
much pressure increases snipe. Find a balance
that is right for your application.
Extreme Duty Planers

Chip Deflector

The segmented chip breaker is factory set for
height, so the only adjustment that can be per-
formed is to the spring pressure.
To adjust the pressure on the chip breaker
segments:
1.
Make sure the planer is disconnected
from the power source!
2.
Rotate the knurled adjustment rings shown
in Figure 18 either left or right to increase or
decrease the spring tension.
Knurled Adjustment Rings
Figure 18. Chip deflector spring pressure controls.
-31-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G9741G9961G9740zG9967zG9967

Table of Contents