Interface Description - Zte MF29A User Manual

4 Phone status indication
5 Phone status indication
6 WiFi indication
7 Power indication

Interface Description

1.Phone: Standard RJ11 connector for Telephone.
2.PSTN: Standard RJ11 connector for PSTN.
3.WAN/LAN: Ethernet connections to internet.
4.LAN1~LAN3: Ethernet connections to computer.
Reset button
5.Reset:
6.ON/OFF: Turn the router ON or OFF.
7.ANT: Connect to external antenna.
8.PRESS ANT ON: To switch between internal antenna and external antenna modes. By default setting,
the router uses the internal antenna. When you connect the router with the antenna through ANT port, you
can press ANT ON to change the router from the internal antenna mode to external antenna mode. Press
ANT on again to change back.
Note: If you press ANT ON without using external antenna, the RSSI signal of the router will be poor.
OFF
Off
Blinking
On
Off
Blinking
On
Off
Blinking
ON
OFF
4
WAN connection not established
(PDP not activated)
PSTN not connected
Calling via PSTN
PSTN connected
Local phone hang up
Phone picked up, ringing or network
CS registering
In calling.
WLAN shut down
WLAN working normally with data
transmission
External power supply works
normally.
External power supply is
disconnected or power off.