References; Useful Notes; Troubleshooting - Oppo BDP-103D User Manual

REFERENCES

Useful Notes

In order to prolong the life of your player, it is recommended that you wait at least 30 seconds
before you power it on after switching it off.
Remove discs and turn the power off after operation.
Some functions of the player may not be applicable to certain discs.
Some discs with special features may not be fully supported by the player. This is not a
malfunction of the unit.
In the case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If the
problem still exists, please follow the troubleshooting instructions or contact an OPPO service
centre.

Troubleshooting

Use this chart to resolve general operational problems. If there are any problems that you cannot resolve,
please contact your OPPO service centre.
Symptom Possible Cause
Audio cable is not properly
connected
Mute is activated
Volume is too low
SACD is played and the audio
No sound
connection is coaxial or optical
digital audio
DVD-Audio is played and the
audio connection is coaxial or
optical digital audio
Video cable is not properly
connected
TV input is not correctly
selected
No picture "Pure Audio" mode engaged
Video output format is not
support by the TV
Video system is not supported
by the TV
Video system is not supported
by the TV
No color Saturation set too low
Incorrect video output port
Incorrect color Incorrect color space setting
Picture rolling or Video system is not supported
split picture by the TV
No disc or incompatible disc
loaded in player
"No Disc" or Dirty disc recording surface
"Unknown Disc"
Disc not properly loaded
error
Condensation on the Laser
pick-up head
Solution
Check audio cable, and then reconnect if necessary.
Press the MUTE button to cancel the mute.
Press the VOL + button to increase the volume to 100.
This is not supported due to copyright restrictions of
SACD. Please use the analogue or HDMI audio output.
Alternatively, you may set SACD Priority to CD mode
and the player will play the CD layer.
This is not supported due to copyright restrictions of
DVD-Audio. Please use the analogue or HDMI audio
output. Alternatively, you may switch to the DVD-
Video playback mode.
Check video cable; reconnect if necessary.
Select the input to which the player is connected.
Press the PURE button to cancel this mode.
Select a proper output resolution that is supported by
your TV.
When playback is completely stopped, set the correct
TV System in the Setup Menu.
When playback is completely stopped, set the correct
TV System in the Setup Menu.
Check the saturation setting on TV and player.
If using "DIAG." output, check that the cable is not
incorrectly plugged into a component video jack.
If using HDMI for video output, check the color space
setting on the TV and player.
When playback is completely stopped, set the correct
TV System in the Setup Menu.
E e j t c i d c s a n d c h e c . k
Eject the disc and clean any dirt or fingerprints.
Eject disc and make sure the label side is facing up
and the record side is facing down.
Turn on the player, eject the disc and leave the player
on for about an hour.
82
Reference
Page
11 _ 17
28
27
17, 51
17, 51
11 _ 15
38
31
54
54
58
13
61
54
2 4
4
24
2