References; Useful Notes; Troubleshooting - Oppo BDP-93 User Manual

REFERENCES

Useful Notes


In order to prolong the service life of your player, it is recommended to wait at least 30 seconds
before you turn it on again after switching it off.

Remove disc and turn power off after operation.

Some functions of the player may not be applicable to certain discs.

Some discs with special features may not be fully supported by the player. This is not a
malfunction of the unit.

In the case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If
the problem still exists, please follow the troubleshooting instructions or contact an OPPO
service center.

Troubleshooting

Use this chart to resolve general operational problems. If there are any problems that you cannot
resolve, please contact your OPPO service center.
Symptom Possible Cause
No sound Audio cable is not properly
connected
Mute is activated
Volume is too low
SACD is played and the audio
connection is coaxial or optical
digital audio
DVD-Audio is played and the
audio connection is coaxial or
optical digital audio
No picture Video cable is not properly
connected
TV input is not correctly
selected
"Pure Audio" mode engaged
Video output format is not
support by the TV
Video system is not supported
by the TV
No color Video system is not supported
by the TV
Saturation set too low
Loose or damaged component
video cables
Incorrect video output port
Incorrect color Incorrect color space setting
Incorrect component video
cable connection
Solution
Check audio cable, and then reconnect if necessary.
Press the MUTE button to cancel the mute.
Press the VOL + button to increase the volume to 100.
This is not supported due to copyright restrictions of
SACD. Please use the analog or HDMI audio output.
Alternatively, you may set SACD Priority to CD mode
and the player will play the CD layer.
This is not supported due to copyright restrictions of
DVD-Audio. Please use the analog or HDMI audio
output. Alternatively, you may switch to the DVD-
Video playback mode.
Check video cable; reconnect if necessary.
Select the input to which the player is connected.
Press the PURE button to cancel this mode.
Select a proper output resolution that is supported by
your TV.
When playback is completely stopped, press and hold
the P/N button or set the correct TV System in the
Setup Menu.
When playback is completely stopped, press and hold
the P/N button or set the correct TV System in the
Setup Menu.
Check the saturation setting on TV and player.
If using component output, check that the three cables
are all properly plugged in and not damaged. Make
sure the color of the plugs match the jacks on both
ends.
If using composite video output, check that the cable is
not incorrectly plugged into a component video jack.
If using HDMI for video output, check the color space
setting on the TV and player.
If using component video output, check the three
component video cables to make sure the signals
match on both ends
81
Reference
Page
10 - 17
30
30
16, 52
16, 52
10 - 11
41
33
33, 55
33, 55
56
13
10
54
13