Temperature Adjustment; Fan Mode Selection - Heat Controller 7602-443 User Manual

User Manual

2.0 Temperature Adjustment

To adjust the temperature on the thermostat, use the left/
right arrow buttons to select the TEMP user option on the
Home Screen and then press the center button or press the
up or down arrow key. The Temperature Adjustment Display
appears and shows either one (in Heat, Cool, or Emergency
Heat modes) or both (in Auto mode) temperature setpoints.
Adjust the setpoints using the up/down arrow buttons.
Navigate between setpoints using the left/right arrow buttons.
Press the center button to save changes.
• Heat Setpoint (default 60°F): options: 55°F to
Maximum Heating Setpoint Limit (section 5.6.8)
• Cool Setpoint (default 80°F): options: Minimum
Cooling Setpoint Limit (section 5.6.8) to 95°F
NOTE 1: The thermostat must be in any mode other than
OFF (section 2) to adjust temperature setpoint(s).
NOTE 2: The thermostat forces a 2°F "dead-band" between
the Heating and Cooling setpoints. While adjusting
the Heating setpoint, the Cooling setpoint may be
automatically increased to enforce a 2°F "dead-
band". Likewise, while adjusting the Cooling
setpoint, the Heating setpoint may be automatically
reduced to enforce a 2°F "dead-band".
NOTE 3: In programmable mode, the TEMP option provides
the ability to temporarily modify setpoint(s) until
the start time of the next program schedule event.
While in non-programmable mode, the TEMP
option provides the ability to modify the setpoint(s).

3.0 Fan Mode Selection

To adjust the Fan Mode on your thermostat, use the left/
right arrow buttons to select the FAN user option from the
Home Screen and then press the center button. The Fan
Menu shows up to 3 possible Fan Operating Modes with the
currently active Fan Operating Mode highlighted. Use the
up/down arrow buttons to select the desired Fan Mode and
press the center button to save your selection. You may
choose from the following Fan Modes:
• Auto (default): Fan only runs with a call for
heating/cooling
• Continuous On: Fan runs continuously with or
without a call for heating/cooling
• Programmed Fan (in Programmable Mode): Fan
runs per Program Schedule settings (reference
section 5.3).
7602-443 COMMUNICATING, PROGRAMMABLE THERMOSTAT
10/13/11
RH 41%
68
RH TEMP
TEMPERATURE
UNTIL 5:00 PM
HEAT
70
CHANGE
PREVIOUS
10/13/11
RH 40%
69
RH TEMP
FAN MENU
AUTO
CONTINUOUS ON
PROGRAMMED FAN
SELECT OPTION
PREVIOUS
4
Heat Controller, Inc.
8:25 AM
FAN AUTO
HUMID ON
°
AUTO
SETPOINT
HEAT 62
COOL 82
MODE FAN MENU
HOLD THIS
COOL
°
°
74
SET TEMP
SAVE
8:27 AM
FAN AUTO
°
OFF
FAN
MODE MENU
HEAT
SAVE