/
(Remote Start): If your vehicle has the remote
vehicle start feature, the keyless entry transmitter
will have a button with this symbol on it.
To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter's lock button,
then immediately press and hold the
transmitter's remote start button for 4 seconds
or until the vehicle's turn signal lamps flash.
The vehicle's doors will be locked.
When the vehicle starts, the parking lamps will
turn on and remain on while the engine is
running, and the DIC will display REMOTE
START ACTIVE PRESS HAZARD SWITCH
TO CANCEL.
3. If it is the first remote start since the vehicle
has been driven, repeat these steps, while
the engine is still running, to extend the engine
running time by 10 minutes. Remote start
can be extended one time.
After entering the vehicle during a remote start,
insert and turn the key to RUN to drive the vehicle.
The engine will shut off automatically after
10 minutes, unless a time extension has been
done or the vehicle's key is inserted into the
ignition switch and turned to RUN.
To manually shut off a remote start, do any of the
following. The parking lamps will turn off.
•
Aim the remote keyless entry transmitter at the
vehicle, and press the remote start button.
•
Turn on the hazard warning flashers.
•
Turn the ignition switch to RUN and then
to OFF.
Your vehicle's engine can be started two times
using the transmitter's remote start feature.
If the remote start procedure is used again before
the first 10 minute time frame has ended, the
first 10 minutes will immediately expire and
the second 10 minute time frame will start.
91