Advertisement
2.3. Windows XP installation
1.
Insert the card into an available ExpressCard slot
2.
Windows will display the 'Found New Hardware Wizard', 'Ethernet controller'
3.
Select 'Install from a list or specific location (Advanced)' and click 'Next'.
Make sure the driver CD is in your CD-ROM/DVD drive.
4.
Select 'Search for the best driver in these locations' and check 'Include this
location in the search:'. Uncheck the other boxes.
5.
Type in E:\ (If your CD-ROM/DVD is E:\) and click "Browse".
6.
Specify the driver location,
e.g. E:\10_100_1000NIC\ Marvell_Yukon\ Windows \WINXP and click 'OPEN',
then 'OK'
7.
When the wizard indicates that it has found a driver for the device, click 'Next'.
Click 'Finish'
2.4.
Verifying the installation under Windows 2000, 2003 and XP
Follow the instructions in this section to verify that the controller was installed
correctly.
1. Right click on the
the 'Hardware' tab and then on the 'Device Manager' button.
2. Double click 'Network adapters', If there is no yellow '!' or '?' in front of 'Marvell
Yukon 88E8053 PCI-e ASF Gigabit Ethernet Controller', the driver has started
correctly.
'My Computer' icon, select 'Properties', left click on
Advertisement
