Clean Up; Site Considerations - Grizzly G5979 Instruction Manual

Clean Up

The unpainted surfaces are coated with a waxy oil
to protect them from corrosion during shipment.
Remove this protective coating with a solvent
cleaner or citrus-based degreaser such as
Grizzly's G7895 Degreaser. Avoid chlorine-based
solvents as they may damage painted surfaces
should they come in contact. Always follow the
usage instructions on the product you choose for
clean up.
Do not use gasoline or
other
solvents. They have low
flash points which make
them extremely flamma-
ble. A risk of explosion
and burning exists if
these
u s e d . Serious personal
injury may occur if this
warning is ignored.
Do not smoke while using
solvents. A risk of explo-
sion or fire exists and may
result in serious personal
injury.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest-
ed. Always work in well-
ventilated areas far from
potential ignition sources
when dealing with sol-
vents. Use care when dis-
posing of waste rags and
towels to be sure they do
not create fire or environ-
mental hazards.
-10-
petroleum-based
p r o d u c t s a r e

Site Considerations

FLOOR LOAD
Your Model G5979 represents a moderate weight
load in a small footprint. Most commercial or
home shop floors should be sufficient to carry the
weight of the Model G5979. If you question the
strength of your floor, you can opt to reinforce it.
Ensure that the stand or bench you use with the
Model G5979 is capable of supporting the
machine.
WORKING CLEARANCES
Working clearances can be thought of as the dis-
tances between machines and obstacles that
allow safe operation of every machine without lim-
itation. Consider existing and anticipated machine
needs, size of material to be processed through
each machine, and space for auxiliary stands
and/or work tables. Also, consider the relative
position of each machine to one another for effi-
cient material handling. Be sure to allow yourself
sufficient room to safely run your machines in any
foreseeable operation and keep dust collection
hoses off the floor and out of the way.
LIGHTING AND OUTLETS
Lighting should be bright enough to eliminate
shadows and prevent eye strain. Electrical circuits
should be dedicated or large enough to handle
combined motor amp loads. Outlets should be
located near each machine so power or extension
cords are not obstructing high-traffic areas. Be
sure to observe local electrical codes for proper
installation of new lighting, outlets, or circuits.
Make your shop "child
safe." Ensure that your
workplace is inaccessible
to youngsters by closing
and locking all entrances
when you are away. Never
allow visitors in your shop
when assembling, adjust-
ing or operating equip-
ment.
G5979 Wood Lathe