American DJ Hyper Gem LED User Instructions page 6

Hyper Gem LED™
1. Tap the MENU button until "SENS" is displayed, press ENTER.
2. Using the UP or DOWN buttons adjust the sensivity level to your
desire.
3. When you found your desired level, press the ENTER, and then press
and hold the MENU button for at least 3 seconds to confirm.
BLND -
Blackout or Stand by mode.
1. Tap the either the MENU button until "BLND" is displayed,
press ENTER. Either Yes or No will be displayed.
2. To activate Blackout tap the UP or DOWN buttons until Yes is
displayed, press ENTER to confim and exit. The fixture will now
be in Blackout mode. To deactivate Blackout mode, select No
and press Enter.
LED -
With this function you can switch the LED on or off
via the control board.
1. Tap the either the MENU button until "LED" is displayed,
press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to switch on the LED, or "OFF" to
switch off the LED.
3. Press ENTER to confirm and exit.
I DSP -
This function will reverse the display 180º.
1. Tap the either the MENU button until "I DSP" is displayed,
press ENTER.
2. Press the UP button to select "DSP i" to activate this function,
or "I DSP" to deactivate this function.
3. Press ENTER to confirm.
American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 11
®
System Menu Hyper Gem LED™
FHRS
of the unit.
1. Tap the either the MENU button until "FHRS" is displayed,
press ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
VER
the unit.
1. Tap the either the MENU button until "VER" is displayed,
press ENTER.
2. The display will show the software version.
American DJ
- With this function you can display the running time
- Use this function to display the Software version of
- www.americandj.com - Hyper Gem LED™ Instruction Manual Page 12
®
System Menu