American DJ Gobo Motion LED User Instructions page 6

Gobo Motion LED
and press Enter.
LED -
With this function you can switch the LED on or off
via the control board.
1. Press the MENU button until "LED" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to switch on the LED, or "OFF" to
switch off the LED.
3. Press ENTER to confirm and exit.
DISP -
This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, press
ENTER.
2. Press the UP button to select "DSIP" to activate this function,
or "DISP" to deactivate this function.
3. Press ENTER to confirm.
TEST
- This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, press
ENTER.
2. The fixture will now run a self test.
FHRS
- With this function you can display the running time
of the unit.
1. Press the MENU button until "FHRS" is displayed, press
ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
American DJ - www.americandj.com - Gobo Motion LED Instruction Manual Page 11
®
System Menu Gobo Motion LED
VER
the unit.
1. Press the MENU button until "VER" is displayed, press
ENTER.
2. The display will show the software version.
Gobo Motion LED
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 9 fixtures maximum. After 9 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
Gobo Motion LED
The Gobo Motion LED comes with 6 replaceable gobos. These
gobos can be interchanged at any time and allows you to customize
your system.
To replace gobo;
1. Unscrew the thumb screw located at the top that hold the gobo
housing.
2. Remove the gobo housing.
3. Once the gobo housing has been removed, remove the retaining
ring that holds the gobo in place. This can easily be done using
needle nose pliers.
4. Remove and replace the gobo with your desired replacement.
Reinsert the retainer ring, and make sure the ring rests firmly
against the gobo.
5. Slide the gobo assembly back into place, and secure the housing
using thumb screw.
American DJ
- Use this function to display the Software version of
- www.americandj.com - Gobo Motion LED Instruction Manual Page 12
®
System Menu
Power Cord Daisy Chain
Gobo Replacement