Table of Contents
Advertisement
Accu UFO
ADDRESS MENU -
AOO1 - A511 (Value) - This is where you set the DMX address of
the unit.
TEST MENU -
T-01 - T-XX (Test) - Tests the functions of each channel. There
are nine channels. Note: Some channels cannot be tested.
PLAY MENU -
RUN - Runs the unit as a "master" or in a stand alone mode. The
unit will run a internal program mode.
AUDI (Audio) - Runs the unit as a "master" or in a stand alone,
sound active mode.
AUTO - This is a precaution mode in case the DMX signal is lost.
There are four settings to choose from:
• "Hold" - This is the default setting, which in case the signal is
lost the fixute will "hold" at the last setting.
• "Close" - The fixture will return to its "home" standing.
• "Auto" - The fixture will go into Auto mode and run a pre-pro-
grammed show.
• "Audi" - The fixture will go into Sound Active mode.
RESE (RESET) MENU -
ALL - Resets all the motors in the unit.
SCAN - Resets the motors that control pan/tilt.
TIME MENU -
LIFE - Displays the fixtures total running time.
CLMT - Clears the fixture running time.
RPAN (REVERSE PAN) MENU -
ON/OFF - When "On" is chosen it will reverse the pan.
DEGR MENU -
360/540 - Switch the degree of the Pan between 360 and 540.
American DJ
- www.americandj.com - Accu UFO Instruction Manual Page 11
®
System Menu
Accu UFO
RTILT (REVERSE TILT) MENU -
ON/OFF - When "On" is chosen it will reverse the tilt.
FINE MENU -
ON/OFF - Switch between 8bit and 16bit movement.
MIC MENU -
M-01-M-70 - With this function you can make the internal mic
more or less sensitive to sound.
DISPLAY MENU -
VALU (DMX-512 Value) - Display the DMX-512 value of each
channel.
D ON - Display will turn off in 2 minutes.
FLIP - "Flips" the digital display 180º.
SPEC MENU -
RDMX - Lets you adjust the DMX address via external controller.
SPEE - Lets you select the movement mode.
DFSE (Default Settings) - Resets the unit to the default settings.
FEED - Pan/Tilt feedback (error correction) on/off.
VER (Version) - Displays the software version
ADJU - Calibration functions
EDIT MENU -
STEP (S-01 - S-48) - These are the steps slots that you write
your programs into. There are at total of 48 steps. See edit pro-
gram.
SCXX (SC01 - SC30) - These are the scenes that are stored in
your program. There are a total of 30 scenes.
REC - This will auto save your custom program.
RUN - This will run your custom program.
American DJ
- www.americandj.com - Accu UFO Instruction Manual Page 12
®
System Menu
Advertisement
Table of Contents
