Quartet IdeaShare User Manual page 11

As shown in Figure C, there are three buttons on the Quartet IdeaShare Board tray
used specifically for copyboard mode:
• Clear - Clears all data from the system and starts a new page. Information
written on the whiteboard needs to be erased. We recommend using a standard
whiteboard eraser (Quartet GhostDuster
whiteboard. The electronic eraser should only be used for making edits during a
session.
• Beam - When the system has data, beams all data stored in the system as a
single page to a supported PDA. A list of supported PDA's can be found on the
Quartet IdeaShare website at www.GBCOffice.com. When the system does not
have data, pressing the Beam button sends an information page to the PDA that
describes where to find the PDA software for use with the Quartet IdeaShare
Board. Software for supported PDA's can be found on the Quartet IdeaShare Board
itself, and the Quartet IdeaShare website at www.GBCOffice.com.
To load the eBeam Viewer application, point the IR window of your PDA device
towards the IR window of the Quartet IdeaShare Board. Press and hold down the
Beam button for 2 seconds. After a moment the eBeam Viewer application will load
to your PDA.
Chapter 2
Clear
Power LED
Status LED
Print
Beam
IR Port
Figure C

eraser, included) for erasing the entire
Page 5