Installation; Hardware Installation; Network Deployment; Setting Up The Network Camera Over The Internet - Toshiba IK-WD04A User Manual

Installation

Hardware Installation

Please verify that your product package contains all the accessories listed in the Package Con-
tents listed on page 11. Depending on the user's application, an Ethernet cable may be needed.
The Ethernet cable should meet the specs of UTP Category 5 or higher.
Hardware Installation is shown in the Quick Start Guide(QSG). Please refer to page 12 of the
QSG.

Network Deployment

In this user's manual, "User" refers to whoever has access to the Network Camera,
and "Administrator" refers to the person who can configure the Network Camera and
grant user access to the camera.
Network Deployment is shown in the Quick Start Guide(QSG). Please refer to page 15 of the
QSG.

Setting up the Network Camera over the Internet

There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use PPPoE.
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below.
1. Connect your Network Camera behind a router, the Internet environment is illustrated below.
Regarding how to obtain your IP address, please refer to Software Installation on page 18 for
details.
Internet
Example Network Environment
16
router. The second way is to utilize a static
WAN (Wide Area Network )
Router IP address : from ISP
LAN (Local Area Network)
Router IP address : 192.168.0.1
Cable or DSL Modem
Internet. The first way is to set
IP. The third way is
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
This client PC sets up
a camera and a router.
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1