Electrolux Tumble Action Installation Instructions And Use And Care Manual page 8

STEP 3
Remove coin slide from coin chute:
• Unhook and remove the coin slide return spring. (see FIGURE 2).
• Turn coin slide mechanism upside down.
• Remove coin slide stop by taking out two screws to the chute bottom
(see FIGURE 3).
(2) Slide Stop
Screws
• Pull coin slide out of coin chute (see FIGURE 4).
FIGURE 4
STEP 4
Turn coin slide upside down and remove screw that holds coin receiver
block (see FIGURE 5).
(1) Receiver Block Screw
FIGURE 5
STEP 5
Remove coin receiver block from coin slide (see FIGURE 6):
• Turn coin slide right side up. Keep coin receiver block in place with
your fingers.
• Carefully lift coin slide from coin receiver block. If necessary, shake
coin slide gently to loosen block.
Coin Receiver
Block
FIGURE 3
Spare Parts
Compartment
and Screw
FIGURE 6
8
8
STEP 6
Set new vend price by adding or removing the appropriate
block-out keys and/or dime inserts according to th Table
of Vend Prices
(see FIGURE 7).
FIGURE 7
TABLE OF VEND PRICE
VEND
PRICE
0
$.10
$.20
$.25
NOTE:
$.35
Black
$.45
colored
$.50
slots are
$.60
closed off
by block- $.70
out key.
$.75
$.85
$.95
$1.00
$1.10
$1.20
$1.25
$1.35
$1.45
$1.50
$1.60
$1.70
$1.75
$1.85
$2.00
To remove block-out keys, pull straight up.
NOTE: Be sure block-out keys and /or dime inserts are
seated properly and ratchet dog is in place with irs spring
connected (see FIGURE 8).
Be sure the proper coin sizing block is in place.
Block-Out
Keys
FIGURE 8
COIN SLOTS
1 2 3 4 5 6 7 8
Ratchet
Dog and
Spring