Framing And Clearances; Select Appliance Location - Heatilator ADVT3428 Owner's Manual

5 5

Framing and Clearances

A. Select Appliance Location
When selecting a location for the appliance it is important
to consider the required clearances to walls (see Fig-
ure 5.1).
WARNING! Risk of Fire or Burns! Provide adequate
clearance around air openings and for service access. Due
to high temperatures, the appliance should be located out
of traffi c and away from furniture and draperies.
1/2 in. (13 mm)
min. appliance
to combustibles
B
E
1 in. (25 mm)
min. pipe to
combustibles
Model
Figure 5.1 Appliance Locations
18
B
Drywall
A
Top Vent
One 90° elbow
Horiz Term
In addition to these framing dimensions, also reference the
following sections:
• Clearances and Mantel Projections (Sections 3.C. and 3.D.)
• Vent Clearances and Framing (Section 6)
Rear Vent
One 90° elbow
Vert Term
A
E
A
inches 34
ADVT3428
ADVR3428 mm 864
Heatilator • AVEO Series DV • 4058-210 Rev F • 10/08
NOTICE: Illustrations refl ect typical installations and are
FOR DESIGN PURPOSES ONLY. Illustrations/diagrams
are not drawn to scale. Actual installation may vary due to
individual design preference.
C
A
G (1219 mm)
maximum
Alcove
Installation
No elbows
Rear Vent
Horiz Term
Two 90° elbows
A Horiz Term
C
B C D
31 1/4 12 34 36 5/8
794 305 864
D
1/2 in. (13 mm) min.
appliance to
combustibles
48 in.
A
Rear vent
One 45° elbow
Horiz Term
A
F
E F G
44 3/4 35
930 1137 889
1 in. (25 mm)
min. pipe to
combustibles
D
F