Chain And Tire Replacement; Replacing The Fuse - Razor Dirt Rocket MX500 Owner's Manual

repaIr anD MaInTenance
Turn power switch "OFF" before conducting any maintenance procedures.
q chain and Tire replacement
Tools required: Phillips screwdriver and two (2) 19mm open wrenches.
1
Loosen screw and remove
chain guard.
4
Install the new chain or
wheel by slipping the chain
around the axle. Slide the axle
into the slots on the frame.
Slide the chain tensioner down
and maneuver the chain onto
the rear sprocket and front
sprocket.
q replacing the fuse
3 Fuse boxes
1
Remove the seat fairing to lo-
cate the 3 fuse boxes attached
to the batteries.
2
Using two 19mm wrenches,
loosen both axle nuts.
5
Re-attach the chain guard.
Test ride and check. Re-adjust
as needed.
Amperage
number
2
Check all 3 fuses to see if
the fuse(s) have burnt out. If the
fuse(s) is(are) damaged, open
the fuse cover. Remove any fuse
that is damaged or burnt out
and replace with a new one of
equal amperage.
Amperage is located on
Note:
top of fuse.
3
Push the chain tensioner
down to loosen the chain and
remove the chain from the
wheel sprocket and motor
sprocket. Push and remove the
wheel downward.
Note: Your hands will get
greasy doing this.
3
Close the fuse cover and
reattach the seat fairing.
6
16-1
16-2
16-3
16-3
16-2
16-1
Note: the arrangement of the
hardware sequence:
Right Side (Throttle)
16-1 Nut
16-2 Washer
16-3 Spacer
Left Side (Brake)
16-1 Nut
16-2 Washer
16-3 Spacer
warnIng:
To prevent shock, please follow
the instructions accordingly and
do not skip any steps.