Kawai CL36 Owner's Manual page 36

Page
36
1. Insert the Adjuster ( j ) approximately 1 cm
into the bottom of the Pedal Board (C).
Unfasten and extend the pedal connection
cable attached to the bottom of the Pedal
Board.
2. Place the Main Unit (A) on the fl oor with its
back side facing down.
3. Place the left and right Side Panels (D)
beside the Main Unit (A), as shown in the
illustration.
4. Loosely attach the left and right Side Panels
(D) to the Main Unit (A) using four 6x30
screws (p), two 6x25 screws (n) and two
4x20 screws (m), as shown in the illustration.
Tighten the screws loosely, leaving an
allowance of approximately 1-2 mm. Ensure
that the correct side panel is used for the left
and right side.
5. Loosly attach the Stand Back Panel (B) to
the partially assembled instrument using
four 6x60 screws (q).
6. Attach the Pedal Board (C) to the left and
right Side Panels using four 4x16 screws
(k).
7 Remove, reposition, then reattach the glides
located on the underside of the left and right
Side Panels (D) so that they protrude.
8. Allow the assembled instrument to stand
upright (vertically) on the fl oor. Securely
tighten all loosely fastened screws, ensuring
that the Main Unit (A), Pedal Board (C) and
Side Panels (D) make close contact, and
that there are no large gaps between the
assembled parts.
9. Cover the screw holes on the left and right
Side Panels using 8 Caps (o).
7
Caution
 Ensure that small children do not
attempt to remove and swallow
the Caps.
(bottom of the Pedal Board) (bottom of the Pedal Board)
(o) (o)
(p) (p)
(o) (o)
(p) (p)
(o) (o)
(q) (q)
Front Front
Back Back
Side Panel Side Panel
(D) (D)
Stand Back Panel (B) Stand Back Panel (B)
Glide Glide
Adjuster Adjuster
(j) (j)
Pedal Board (C) Pedal Board (C)
(k) (k)
Main Unit( A) Main Unit( A)
Pedal Board (C) Pedal Board (C)
Aduster hole Aduster hole
Adjuster hole Adjuster hole
Main Unit( A) Main Unit( A)
(n) (n)
(m) (m)
Front Front
Side Panel Side Panel
(D) (D)
(n) (n)
Back Back
(m) (m)
Glide Glide
Side Panel Side Panel
(D) (D)
Cap (o) Cap (o)