First Fire - Pelpro Freestanding Owner's Manual

Operation Instructions
COMPLETE THE CHECK LIST (Page 9) PRIOR TO LIGHTING YOUR FIRST FIRE
FOLLOW THE ARROWS TO START YOUR APPLIANCE FOR THE FIRST TIME
IT IS CRITICAL FOR THE CORRECT OPERATION OF YOUR STOVE THAT THE FOLLOWING STEPS
BE PERFORMED! A pellet stove, like most things in life is NOT a plug and play appliance.
SETTING THE AIR INLET DAMPER
Because the appliance is made in one location and elevation,
then shipped, moved and installed to a different location, at a
different elevation, vented differently and then using different fuels. It is
not possible for the manufacture to factory set your stove to work
properly without some adjustments.
The damper helps to control the amount of airflow supplied for
combustion.
Damper pushed in all the way airflow is minimum.
Damper pulled out all the way airflow is increased.
To get the appliance started, push the air damper in all the
Way, then pull outward approximately 1/2".
This may not be the final setting.
We will cover FINE TUNNING YOUR STOVE later in this manual.
OPENING AND CLOSING THE MAIN DOOR:
Open the stove door by rotating the handle COUNTER
CLOCKWISE, toward the TOP of the stove, until the handle is
about the 3 o'clock position. Swing door open to the
left.
Close the stove door by keeping the handle at the
3 o'clock position. Push the door firmly against the stove.
Rotate the handle downward to the 6 0'clock position to lock.
SEATING THE PELLET BURN GRATE:
Diagram A
The SUPER GRATE multi-Fuel Burn Grate comes in one piece: (B)
and sits in the Burn Pot (A)
Diagram B and C
You may need adjust the spacer tab (C) if the burn grate fits loosely in
the burn pot or if the Igniter hole needs to be closer to the igniter.
To do so grasp the burn grate adjustment tab (C) with a pair of pliers
and bend it slightly inward or outward, until the burn grate top rest
tightly onto the burn pot and grate fits firmly, with slight play, in the
burn pot.
www.pelprostoves.com
B
7081-146E
G
C
Diagram A
C
Diagram B
Diagram C
A
21