Battery Installation And Charging - AT&T CL80121 User Manual

Getting started

Battery installation and charging

Install the battery as shown on page 7.
the battery, the screen indicates the battery status (see the table
below). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 10 hours of continuous charging.
the table on page 29 for battery operating times.
If the screen shows Place in charger and
charge the handset without interruption
give the handset enough charge to use the telephone for a short
time. The following table summarizes the battery charge indicators
and actions to take.
Battery indicators
The screen is blank,
or shows Place in
charger and
(flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
Battery status
Battery has no or
very little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
Once you have installed
flashes, you need to
for at least 30 minutes to
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
6
See