Installation - Jensen AWM914 Owner's Manual

INSTALLATION

It's a good idea to read all of the instructions before beginning the
installation. We recommend having your JENSEN AWM914 installed
by a reputable RV dealership.
Tools and Supplies
You will need these tools and supplies to
install your AWM914:
•
Phillips screwdriver
•
Wire cutters and strippers
•
Tools to remove existing
(screwdriver, socket wrench set or
other tools)
•
Electrical tape
•
Crimping tool
•
Volt meter/test light
•
Crimp connections
•
16 gauge wire for power connections
• 16 – 18 gauge speaker wire
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove
the negative (-) battery cable prior to installation.
NOTE: If the AWM914 is to be installed in a vehicle equipped with
an on-board drive or navigation computer, do not disconnect the
battery cable. If the cable is disconnected, the computer memory
may be lost. Under these conditions, use extra caution during
installation to avoid causing a short circuit.
Select Mounting Location
Select a mounting location, taking care to avoid the following:
•
Places exposed to heat-radiating appliances such as electric
radio
2
heaters
•
Adjacent to other equipment that radiates heat
•
Poorly-ventilated or dusty places
•
Moist or humid locations
Preparing the Opening
Use the mounting hole diagram (below) to measure and cut a mounting
hole, and mount the unit using the M3x20mm self-tapping screws.
NOTE: Before cutting the mounting hole, make sure the area
behind the mounting location is clear of wires and fuel, vacuum
and or brake lines.
Mounting the Radio
Route power, speaker and antenna cables through the hole, and
connect them to the unit as outlined in the wiring diagram. After
ensuring correct connections, test operation.
AWM914