Cleaning The Outside Of The Machine - Brother DCP-6690CW User Manual

g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cartridge, for
example Black, the LCD may ask you to
verify that it was a brand new one (for
example, Did You Change
Black). For each new cartridge you
installed, press Yes to automatically reset
the ink dot counter for that colour. If the ink
cartridge you installed is not a brand new
one, be sure to press No.
• If the LCD shows No Cartridge or
Cannot Detect after you install the ink
cartridges, check that the ink cartridges
are installed correctly.
WARNING
If ink gets in your eyes, wash them out with
water at once and call a doctor if you are
concerned.
CAUTION
DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink left
in the cartridge.
DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
If ink gets on your skin or clothing
immediately wash it off with soap or
detergent.
If you mix the colours by installing an ink
cartridge in the wrong position, clean the
print head several times after correcting the
cartridge installation.
Troubleshooting and Routine Maintenance
Once you open an ink cartridge, install it in
the machine and use it up within six months
of installation. Use unopened ink cartridges
by the expiration date written on the
cartridge package.
DO NOT dismantle or tamper with the ink
cartridge, this can cause the ink to leak out
of the cartridge.
Cleaning the outside of the
machine
Cleaning the Touchscreen as follows:
CAUTION
Turn off the power switch when you clean
the Touchscreen.
DO NOT use any type of liquid cleaners
(including ethanol).
a
Clean the Touchscreen with a dry soft
cloth.
B
B
87