4. Hardware Installation
Please refer to the following steps.
1.
Shut down the computer and remove the computer
case.
2.
Remove any existing graphics card on your
mainboard.
3.
Press this card into the AGP slot firmly and make sure
it is fully installed. Then secure the card with a bracket
screw.
4.
Please insert other cards, plug all the cables, install
other devices, and close the computer case.
5.
Turn on the computer. You are ready to install the
driver. Please go to software installation section.
Hardware Installation
If your mainboard has any onboard VGA capability,
please disable it before installation.
The figure is for reference only; please regard to the
products on hand.
10